Harga yang bagus  on line

rincian produk

Rumah > Produk >
High Temperature EDI Module
>
EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

Nama merek: Aquacells
Nomor Model: EIMD-20CP
Informasi Rinci
Tempat asal:
Cina
Sertifikasi:
FDA,EU,CE,RoHS,REACH
Tingkat Penolakan Garam:
Lebih besar dari 99%
Masa garansi:
12 Bulan
Catu daya:
220 V/50 Hz
Ukuran:
500mm x 300mm x 200mm
Aplikasi:
Pemurnian air suhu tinggi dalam proses industri
Rentang operasi PH:
2 sampai 11
Bahan:
Elektroda polimer dan titanium bermutu tinggi
Nama Produk:
Modul EDI Suhu Tinggi
Berat:
15kg
Interval pemeliharaan:
Setiap 6 bulan
Laju Aliran:
0,5 hingga 3,0 m³/jam
Kisaran Suhu Pengoperasian:
Hingga 95°C
Penghapusan konduktivitas listrik:
Hingga 99%
Tekanan Maksimum:
6 bar
Tingkat pemulihan air:
Hingga 85%
Menyoroti:

High Temp EDI Module

,

EDI Module Condensate Polishing

,

EDI Water Purification Condensate Polishing

Deskripsi Produk
EIMD-20CP Condensate Polishing Module With 16 MΩ*Cm Resistivity And 90-95% Recovery Using Continuous Electrodeionization

The Aquacells EIMD-CP module is engineered to replace mixed bed technology for condensate polishing treatment. Utilizing continuous electrodeionization (EDI) technology, this system produces water with resistivity exceeding 16 MΩ*cm without requiring shutdown and regeneration cycles.

Feed Water Specifications
Parameter Specification
Feed Water Source Condensate water
Temperature 60-65 ℃ (60-65 ℉)
Feed Pressure 1.4-7 bar (20-100 psi)
Fe Content <0.01 ppm
pH Range 4-11
Oil Content <0.2 ppm
Typical Module Performance
Parameter Specification
Typical Recovery 90-95%
Maximum Feed Pressure 7 bar (100 psi)
Maximum Feed Temperature 65 ℃ (149 ℉)
DC Voltage* 0-300 V
DC Amperage 0-6 A
Product Resistivity >16 MΩ·cm
*Voltage required depends on module size
*The information provided contains general descriptions or performance characteristics that may not always apply as described in actual use cases or may change due to further product development. An obligation to provide the respective characteristics shall only exist if expressly agreed upon in the terms of the contract.