Giá tốt.  trực tuyến

Chi tiết sản phẩm

Nhà > các sản phẩm >
High Temperature EDI Module
>
EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

Tên thương hiệu: Aquacells
Số mẫu: EIMD-20CP
Thông tin chi tiết
Nguồn gốc:
Trung Quốc
Chứng nhận:
FDA,EU,CE,RoHS,REACH
Tỷ lệ từ chối muối:
Lớn hơn 99%
Thời hạn bảo hành:
12 tháng
Nguồn điện:
220 V/50 Hz
Kích thước:
500mm x 300mm x 200mm
Ứng dụng:
Lọc nước ở nhiệt độ cao trong quy trình công nghiệp
Phạm vi hoạt động PH:
2 đến 11
Vật liệu:
Điện cực polymer và titan cao cấp
Tên sản phẩm:
Mô-đun EDI nhiệt độ cao
Cân nặng:
15 kg
Khoảng thời gian bảo trì:
Cứ sau 6 tháng
Tốc độ dòng chảy:
0,5 đến 3,0 m³/giờ
Phạm vi nhiệt độ hoạt động:
Lên đến 95°C
Loại bỏ độ dẫn điện:
Lên đến 99%
Áp suất tối đa:
6 bar
tỷ lệ thu hồi nước:
Lên đến 85%
Làm nổi bật:

High Temp EDI Module

,

EDI Module Condensate Polishing

,

EDI Water Purification Condensate Polishing

Mô tả sản phẩm
EIMD-20CP Condensate Polishing Module With 16 MΩ*Cm Resistivity And 90-95% Recovery Using Continuous Electrodeionization

The Aquacells EIMD-CP module is engineered to replace mixed bed technology for condensate polishing treatment. Utilizing continuous electrodeionization (EDI) technology, this system produces water with resistivity exceeding 16 MΩ*cm without requiring shutdown and regeneration cycles.

Feed Water Specifications
Parameter Specification
Feed Water Source Condensate water
Temperature 60-65 ℃ (60-65 ℉)
Feed Pressure 1.4-7 bar (20-100 psi)
Fe Content <0.01 ppm
pH Range 4-11
Oil Content <0.2 ppm
Typical Module Performance
Parameter Specification
Typical Recovery 90-95%
Maximum Feed Pressure 7 bar (100 psi)
Maximum Feed Temperature 65 ℃ (149 ℉)
DC Voltage* 0-300 V
DC Amperage 0-6 A
Product Resistivity >16 MΩ·cm
*Voltage required depends on module size
*The information provided contains general descriptions or performance characteristics that may not always apply as described in actual use cases or may change due to further product development. An obligation to provide the respective characteristics shall only exist if expressly agreed upon in the terms of the contract.