Bom preço  on-line

Detalhes dos produtos

Casa > produtos >
High Temperature EDI Module
>
EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

Nome da marca: Aquacells
Número do modelo: EIMD-20CP
Informações detalhadas
Lugar de origem:
China
Certificação:
FDA,EU,CE,RoHS,REACH
Taxa da rejeção de sal:
Maior que 99%
Período de garantia:
12 meses
Fonte de energia:
220 V/50 Hz
Dimensões:
500 mm x 300 mm x 200 mm
Aplicativo:
Purificação de água em alta temperatura em processos industriais
Faixa operacional de pH:
2 a 11
Material:
Eletrodos de polímero e titânio de alta qualidade
Nome do produto:
Módulo EDI de alta temperatura
Peso:
15kg
Intervalo de manutenção:
A cada 6 meses
Taxa de fluxo:
0,5 a 3,0 m³/h
Faixa de temperatura operacional:
Até 95°C
Remoção de condutividade elétrica:
Até 99%
Pressão Máxima:
6 bar
Taxa de recuperação da água:
Até 85%
Destacar:

High Temp EDI Module

,

EDI Module Condensate Polishing

,

EDI Water Purification Condensate Polishing

Descrição do produto
EIMD-20CP Condensate Polishing Module With 16 MΩ*Cm Resistivity And 90-95% Recovery Using Continuous Electrodeionization

The Aquacells EIMD-CP module is engineered to replace mixed bed technology for condensate polishing treatment. Utilizing continuous electrodeionization (EDI) technology, this system produces water with resistivity exceeding 16 MΩ*cm without requiring shutdown and regeneration cycles.

Feed Water Specifications
Parameter Specification
Feed Water Source Condensate water
Temperature 60-65 ℃ (60-65 ℉)
Feed Pressure 1.4-7 bar (20-100 psi)
Fe Content <0.01 ppm
pH Range 4-11
Oil Content <0.2 ppm
Typical Module Performance
Parameter Specification
Typical Recovery 90-95%
Maximum Feed Pressure 7 bar (100 psi)
Maximum Feed Temperature 65 ℃ (149 ℉)
DC Voltage* 0-300 V
DC Amperage 0-6 A
Product Resistivity >16 MΩ·cm
*Voltage required depends on module size
*The information provided contains general descriptions or performance characteristics that may not always apply as described in actual use cases or may change due to further product development. An obligation to provide the respective characteristics shall only exist if expressly agreed upon in the terms of the contract.