İyi bir fiyat.  çevrimiçi

Ürün ayrıntıları

Evde > Ürünler >
High Temperature EDI Module
>
EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

EIMD-20CP High Temp EDI Module Water Purification Condensate Polishing Module

Marka Adı: Aquacells
Model Numarası: EIMD-20CP
Ayrıntılı Bilgiler
Menşe yeri:
Çin
Sertifika:
FDA,EU,CE,RoHS,REACH
Tuz Reddetme Oranı:
%99'dan büyük
Garanti süresi:
12 Ay
Güç kaynağı:
220 V/50 Hz
Boyutlar:
500mm x 300mm x 200mm
Başvuru:
Endüstriyel proseslerde yüksek sıcaklıkta su arıtma
PH çalışma aralığı:
2'den 11'e
Malzeme:
Yüksek dereceli polimer ve titanyum elektrotlar
Ürün adı:
Yüksek Sıcaklık EDI Modülü
Ağırlık:
<%0,6
Bakım aralığı:
Her 6 ayda bir
Akış Hızı:
0,5 ila 3,0 m³/saat
Çalışma Sıcaklığı Aralığı:
95°C'ye kadar
Elektriksel iletkenliğin giderilmesi:
%99'a kadar
Maksimum Basınç:
6 bar
Su geri kazanım oranı:
%85'e kadar
Vurgulamak:

High Temp EDI Module

,

EDI Module Condensate Polishing

,

EDI Water Purification Condensate Polishing

Ürün Tanımı
EIMD-20CP Condensate Polishing Module With 16 MΩ*Cm Resistivity And 90-95% Recovery Using Continuous Electrodeionization

The Aquacells EIMD-CP module is engineered to replace mixed bed technology for condensate polishing treatment. Utilizing continuous electrodeionization (EDI) technology, this system produces water with resistivity exceeding 16 MΩ*cm without requiring shutdown and regeneration cycles.

Feed Water Specifications
Parameter Specification
Feed Water Source Condensate water
Temperature 60-65 ℃ (60-65 ℉)
Feed Pressure 1.4-7 bar (20-100 psi)
Fe Content <0.01 ppm
pH Range 4-11
Oil Content <0.2 ppm
Typical Module Performance
Parameter Specification
Typical Recovery 90-95%
Maximum Feed Pressure 7 bar (100 psi)
Maximum Feed Temperature 65 ℃ (149 ℉)
DC Voltage* 0-300 V
DC Amperage 0-6 A
Product Resistivity >16 MΩ·cm
*Voltage required depends on module size
*The information provided contains general descriptions or performance characteristics that may not always apply as described in actual use cases or may change due to further product development. An obligation to provide the respective characteristics shall only exist if expressly agreed upon in the terms of the contract.